At SHOT Show 2015’s Industry Day at the Range, I wandered over to the far south end of the festivities, as I usually do, to start a methodical perusal northward. The first booth on the right was that of the Standard Manufacturing Company, a branch of the Connecticut Shotgun Manufacturing Company. Their DP-12 was garnering much attention.
The DP-12 is a double-barreled, pump-action bullpup 12 gauge shotgun. Since it is akin to marrying two pumps side-by-side, the gun was built to be completely ambidextrous. There are thumb safeties on both sides. Loading in done through a bay behind the handgrip. The receiver is made from a solid block of forged 775 aluminum billet.
The single trigger of the DP-12 fires the right barrel on the first pull, then the left barrel on the second pull. Hulls are sent downward via the loading/ejection port. This shotty fires 2 3/4″ or 3″ shells of shot or slug. With two magazine tubes holding seven rounds each and the chambers loaded, the total capacity for the DP-12 is a staggering 16 shots!
The barrels of the DP-12 are 19 inches. Overall, the shotgun is 29.5 inches. It tilts a scale Continue reading

















